Similar Articles |
|
U.S. CPSC February 15, 2005 |
Sea Gull Lighting Products Recall of Ceiling Light Fixtures Due to a manufacturing defect in a component part, the light fixture could fall and strike a person beneath the light fixture. The fixture also poses a laceration risk if the lamp breaks. |
U.S. CPSC July 22, 2008 |
Indoor Lighting Fixtures Recalled by Lithonia Lighting Due to Fire Hazard A thermal protector could be missing from the lighting fixtures, posing a risk of overheating and fire. |
U.S. CPSC June 10, 2008 |
Progress Lighting Recalls Ceiling-Mounted Indoor Light Fixtures; Lights Can Fall Posing an Impact Hazard A cable that supports the light fixture from the ceiling can fail, causing the fixture to fall and injure nearby consumers. |
U.S. CPSC March 19, 2008 |
Progress Lighting Recalls Ceiling-Mounted Outdoor Light Fixtures; Lights Can Fall Off Mounting and Injure Consumers A weld that affixes a mounting bracket to the ceiling pan can fail, which can cause the fixture to fall and injure nearby persons. |
U.S. CPSC March 3, 2010 |
Outdoor Lighting Fixtures Recalled by American Electric Lighting Due to Shock Hazard Improper wiring in the light fixtures poses a shock hazard to consumers. |
U.S. CPSC August 27, 2008 |
Indoor Lighting Fixtures Recalled by Lithonia Lighting Due to Impact Hazard The glass reflector can separate from the fixture and fall, posing a risk of injury to consumers below the fixture. |
U.S. CPSC August 7, 2008 |
Progress Lighting Recalls Indoor Light Fixtures; Lights Can Unexpectedly Fall Posing an Impact Hazard The ceiling-mount assembly that supports the light fixture can fail, causing the fixture to unexpectedly fall and injure consumers. |
U.S. CPSC October 9, 2007 |
Fluorescent Ceiling Light Fixtures Sold Exclusively at Home Depot Recalled by Lithonia Lighting Due to Shock Hazard A wire inside the light fixture could be loose, posing an electrical shock hazard to consumers. |
U.S. CPSC February 10, 2004 |
Fluorescent Light Fixtures Recalled by Progress Lighting The lamp holders on the fluorescent lights can overheat, causing the fixture to melt or burn, presenting a fire hazard. |
U.S. CPSC May 23, 2006 |
Light Fixtures Recalled After Reports of Units Falling Two nuts in a mounting mechanism of these light fixtures were not attached. The fixture could detach, fall and possibly hit consumers. |
U.S. CPSC September 25, 2003 |
Ceiling Fans Recalled by Vaxcel International Co. Ltd. About 80 of these units were improperly assembled with a metal sleeve that could cause exposed wiring. If this occurs, consumers are at an increased risk of receiving an electrical shock during installation or removal. |
U.S. CPSC March 11, 2005 |
Lithonia Lighting Recall of Indoor HID Light Fixture Cords The cord of the light fixture can drip plasticizer fluid onto the light fixture, which can degrade the acrylic reflector, causing it to crack and fall. Falling pieces of acrylic can injure a person below the fixture. |
U.S. CPSC September 23, 2008 |
Gotham Lighting Recalls Compact Fluorescent Recessed Ceiling Lights; Can Fail to Work in an Emergency The relay on the backup battery of the lights could be programmed incorrectly and prevent the lights from functioning in an emergency. |
U.S. CPSC November 21, 2007 |
Cooper Lighting Recalls Fluorescent Shop Lights Due to Electrical Shock Hazard When the two prongs on the plug's electrical cord are touched simultaneously while lamps are installed, the light can pose an electric shock hazard to consumers. |
U.S. CPSC March 29, 2004 |
Lithonia Lighting Recall of Indoor HID Light Fixtures A component in the light fixture can leak fluid, which can degrade the acrylic lenses and reflectors, causing them to crack and fall. Falling pieces of acrylic can injure someone below the fixture. |
U.S. CPSC April 30, 2010 |
Chain Sets Sold with Commercial Light Fixtures Recalled by Cooper Lighting Due to Injury Hazard An "S" hook on the chain connecting the fixture to the ceiling can straighten when subjected to high impact forces, resulting in the light fixture falling. This poses an injury hazard to consumers. |
U.S. CPSC March 25, 2009 |
Holiday Lights Recalled by Four Star Group USA Due to Fire Hazard; Sold Exclusively at Safeway Stores Electrical wiring in the lights can overheat, posing a fire hazard to consumers. |
U.S. CPSC August 12, 2008 |
Cooper Lighting Recalls Emergency and Exit Lights; Could Fail to Stay Illuminated in an Emergency The lights can malfunction and not stay illuminated in the event of a power failure. This could result in a failure to provide adequate lighting to guide building occupants to an exit in an emergency. |
U.S. CPSC October 25, 2006 |
Streetlights Recalled by Beacon Products Due to Injury Hazard to Passersby The lighting fixtures could fall from their lamp posts due to a problem with the coupling system used to secure them. This poses a risk of injury for persons beneath the fixtures. |
U.S. CPSC October 2, 2003 |
Technuity Inc. Recall of Back-Up Power Supply Systems When used in conjunction with another power protection device, the power supply device can spark, posing a fire hazard to consumers. |
U.S. CPSC August 9, 2011 |
Emergency Exit Signs Recalled by Best Lighting Products Due to Failure to Illuminate The fixtures can malfunction and fail to illuminate in the event of a power failure. This could result in a failure to provide adequate lighting to guide building occupants to an exit in the event of an emergency. |
U.S. CPSC November 30, 2004 |
Classic Sport Companies Inc. Recall of Table Soccer Games The lighting structures may spark if the tube lights are not properly installed, posing a fire hazard. |
U.S. CPSC March 8, 2005 |
Lithonia Lighting Recall of Indoor HID Light Fixtures A component in the light fixture can leak fluid, which can degrade the acrylic lenses and reflectors, causing them to crack and fall. Falling pieces of acrylic can injure someone below the fixture. |
U.S. CPSC December 28, 2006 |
Trim Assembly Kits for Recessed Light Fixtures Recalled By Progress Lighting Due To Risk of Falling Parts Heat from the light bulb can cause the fixture's plastic trim to soften and melt, causing the trim and lens to fall. This can result in laceration injuries to nearby consumers. Models were made in China and have model numbers: 8009-60, 8010-60 or 8011-60. |
U.S. CPSC August 15, 2006 |
Gotham Light Fixtures Recalled Due to Risk of Falling Parts The lower portion of the reflector/trim assembly could detach and fall from the ceiling, striking consumers. |
U.S. CPSC May 9, 2007 |
Cooper Lighting Emergency Lights Recalled, Could Fail to Illuminate in an Emergency A circuit board in the light could malfunction, preventing the lights from illuminating in the event of a power failure. |
U.S. CPSC August 16, 2006 |
Tu-Wire(R) Dimming Ballasts Used With Compact Fluorescent Lights Recalled for Shock Hazard If not properly grounded, these ballasts can present a risk of electric shock to persons who come in contact with the ballast or with a light fixture that incorporates the ballast. |
U.S. CPSC November 18, 2008 |
Lithium-Ion Batteries Used with Bicycle Lights Recalled By DiNotte Lighting Due to Burn Hazard A loose wiring connection and improper venting can cause the battery to overheat, posing a burn hazard to consumers. |
U.S. CPSC September 23, 2010 |
Molenaar LLC Recalls Night Lights Due to Fire and Shock Hazard The night lights can become hot to the touch and melt, resulting in risk of possible shock or fire. |
U.S. CPSC November 4, 2004 |
Cordelia Lighting Recall of Hampton Bay Light Fixtures Sold at Expo Design Centers The decorative metal rings on the ends of the lamp fixtures can detach. Consumers could suffer minor burns if they touch the hot rings. |
U.S. CPSC August 20, 2009 |
Pensi Ceiling Fans Recalled by The Modern Fan Co. Due to Fall and Injury Hazard The internal coupler that connects the down rod assembly to the motor can break and cause the fan to fall from the ceiling, posing an injury hazard to consumers. |
U.S. CPSC November 6, 2001 |
Progress Lighting Recall Fluorescent Lights The lights are improperly wired, posing a fire hazard. |
U.S. CPSC March 1, 2005 |
Ginger Recall of Bathroom Light Fixtures The glass shades can separate from the light fixture, posing a risk that a consumer could be cut by the broken glass if the shade were to fall and break. |
U.S. CPSC August 22, 2008 |
Power Light Modules Recalled by GCI Technologies Due to Fire and Burn Hazards Internal wiring in the module's circuit boards is incorrectly installed, posing a risk of an electrical fire and burn hazards to consumers. |
U.S. CPSC August 3, 2007 |
LED Lights Recalled by Plan 9 Due to Fire Hazard The circuit board in the lights can overheat, posing a risk of fire. |
U.S. CPSC December 11, 2008 |
Commercial Frozen Food Merchandisers Recalled by Tyler Refrigeration Due to Fire Hazard Incomplete/incorrect light bulb installation can result in electrical arcing in the fixture, which can pose a fire hazard to consumers. |
U.S. CPSC March 4, 2009 |
Holiday Lights Recalled by Universal Distribution Center Due to Shock and Fire Hazard The lights have undersized wires that can easily pull out of the plugs and light sockets becoming exposed. This poses an electric shock and fire hazard to consumers. |
U.S. CPSC April 24, 2003 |
DesignPac Inc. Recall of Oil Lamps The glass wick holder can shatter when lit, posing a fire hazard. |
U.S. CPSC December 29, 2006 |
Trim Assembly Kits for Recessed Light Fixtures Recalled By Prescolite Inc. Due to Risk of Falling Parts Heat from the light bulb can cause the fixture's plastic trim to soften and melt, causing the trim and lens to fall. This can result in laceration injuries to nearby consumers. Models were made in China and have model numbers: TL60 and TL62. |
U.S. CPSC December 5, 2006 |
Stanley Security Solutions Inc. Announces Recall of Door Handle Locks, Failure Could Lead to Entrapment in an Emergency The locks can fail and the door cannot be unlocked from the inside, posing an entrapment hazard. This failure could lead to the inability to vacate a location in an emergency. |
U.S. CPSC December 13, 2001 |
Homemaster Recalls Outdoor Lighting Timers Outdoor Lighting Timers have reversed polarity in the wiring, potentially allowing a current to flow through a consumer's body, posing a shock hazard to consumers... |
U.S. CPSC November 26, 2003 |
American Greetings Corp. Recall of Crazy Bounce Balls The balls could break apart, posing a choking hazard to young children. |
U.S. CPSC March 17, 2004 |
APA Marketing Inc. Recall of Home Entertainment Wall Units The control box for the touch dimmer lighting mechanism can overheat, posing a fire hazard to consumers. |
U.S. CPSC November 20, 2008 |
Watts Water Technologies Recalls Rotor and Shaft Assemblies Due to Fire Hazard If the assembly was installed in a fire suppression system and remained in a closed position, sufficient water might not have been available in the event of a fire. This posed a fire hazard to consumers. |
U.S. CPSC July 2, 2003 |
International Adapter Plugs Recalled by Franzus Company LLC The adapter plug can separate, exposing live electrical conductors, posing an electrocution and shock hazard to consumers. |
U.S. CPSC July 1, 2005 |
Two's Company Inc. Recall of Shell Candles Sea Urchin Shell Candles candles can burn at an excessive height or cause the outer shell to catch fire, posing a potential fire and burn hazard. |
U.S. CPSC May 8, 2003 |
Wal-Mart Recalls Fabric Lanterns The fabric is not flame retardant and can be ignited by the lantern's votive candle, posing a fire hazard. |
U.S. CPSC August 8, 2007 |
Stubben Steeltec Horseback Riding Stirrups Recalled Due to Fall Hazard The stirrup's hinges can break, posing a fall hazard to riders. |
U.S. CPSC March 21, 2007 |
Home Decorators Collection Recalls Wall Sconces Due to Electrical Shock Hazard A missing back plate exposes consumers to live wires, posing a risk of electrical shock to consumers changing the light bulb. |
U.S. CPSC November 26, 2003 |
American Greetings Corp. Recall of Zipper Pulls The product could separate and detach from the zipper, posing a choking hazard to young children. |